Disposable En Core® Sampler Sampling Procedures

NOTE:

  1. En Core Sampler is a Single Use device. It cannot be cleaned and/or reused.
  2. En Core Sampler is designed to store soil. Do not use En Core Sampler to store solvent or free product!
  3. En Core Sampler must be used with En Core® T-Handle and/or En Core® Extrusion Tool exclusively. (These items are sold separately.)

Using The En Core® T-Handle

 

Before Taking Sample:

  1. Hold coring body and push plunger rod down until small o-ring rests against tabs. This will assure that plunger moves freely.

  2. Depress locking lever on En Core T-Handle. Place coring body, plunger end first, into open end of T-Handle, aligning the (2) slots on the coring body with the (2) locking pins in the T-Handle. Twist coring body clockwise to lock pins in slots. Check to ensure Sampler is locked in place. Sampler is ready for use.


Click to Enlarge

Taking Sample:

  1. Turn T-Handle with T-up and coring body down. This positions plunger bottom flush with bottom of coring body (ensure that plunger bottom is in position). Using T-Handle, push Sampler into soil until coring body is completely full. When full, small o-ring will be centered in T-Handle viewing hole. Remove Sampler from soil. Wipe excess soil from coring body exterior.

  2. Cap coring body while it is still on T-handle. Push cap over flat area of ridge.  Push and twist cap to lock arm in place. Cap must be seated to seal sampler (see diagram below).


Click to Enlarge.

  


Download PDF of Directions
Notice: You will need Adobe Acrobat Reader to view this Report.
Install Adobe Acrobat Reader